Vehicle Magnet Order

Innovative Signs is building a set of 50 vehicle magnets. This set is for DIRECTV Authorized Contractors. We first had our cut vinyl machine cut the vinyl so we can later weed it. After the long roll of vinyl was cut by the machine, we removed the excess material by hand. We pull away at the vinyl not part of the final product. After the vinyl roll was weeded we looked over it in case any of the letters might of been accidentally pulled off. After a product inspection, we applied transfer paper over the vinyl and started to cut out the shape of the final product using the outline boxes. Now the standard size of a vehicle magnet is 12×24. We trimmed the roll of magnetic material to this 12×24 size. After cleaning the magnet’s surface, we aligned the vinyl and peeled away the transfer paper leaving  behind the vinyl attached to the magnetic material. Here are the pictures of the process for these DIRECTV Magnets. This is the same process for every vehicle magnet we make.

Here we are starting the weeding process. We got a few of them down but there’s still a lot more left to do. That little dot after DIRECTV is actually the Registered Trademark symbol.

This is a closeup of the Registered Trademark symbol. This super small little “R” is going to be hard to weed out.

After playing around with the tiny little piece of vinyl, it’s finally done with. There are still many more “R’s” that must be dealt with.

This is a finished roll of weeded vinyl. We check the letters and other shapes to make sure none of the required letters and shapes got removed. That or if there are any leftover pieces that still need to be removed.

After using transfer paper we chop them up and cut the magnets to size.

After applying the vinyl to the magnet’s surface you now have this magnet. We take the corners off and let the customer know they are ready for pick up. If you need a set of DIRECTV Authorized Contractor Magnets look no further than Innovative Signs of Tucson.